Protocols · BioStudioAI

DNA ligation protocol

Last reviewed Author: BioStudioAI

Answer first. T4 DNA ligase joins compatible ends; molar ratio, insert quality and controls decide colony quality more than ligase brand.

T4 DNA ligase joins compatible ends; molar ratio, insert quality and controls decide colony quality more than ligase brand.

Principle

T4 DNA ligase joins compatible ends; molar ratio, insert quality and controls decide colony quality more than ligase brand. This page gives a vendor-neutral bench workflow. Follow your kit insert for kit-specific volumes, and validate the assay in your own matrix before using it for decisions.

Materials and equipment

ItemNotes
Samples and standardsSame matrix where possible; standards on every plate/run
Core reagentsGeneric names; record supplier, catalogue and lot in the run record
EquipmentCalibrated pipettes, appropriate reader/instrument, timers
ConsumablesLow-bind tubes/plates as the assay requires

Solutions to prepare

Prepare buffers fresh or verify stored buffers. Use the buffer recipe, dilution and molarity calculators in Tools to scale recipes, and record what you actually made.

Procedure

  1. Dephosphorylate vector where background is a problem; gel-purify insert and vector.
  2. Calculate insert mass with the ligation calculator (commonly 3:1 insert:vector).
  3. Set up ligase reactions plus vector-only and no-ligase controls.
  4. Incubate (commonly 1 h room temperature or overnight 16°C).
  5. Transform and compare colony counts against controls.

Bench mode

Work through the procedure top to bottom, ticking steps off on paper or a phone. Keep total time in mind: this protocol takes about 1 h to overnight.

Expected results and QC

Vector-only colonies much lower (often under 10-20%) than the ligation. If a criterion fails, troubleshoot before analyzing samples: see Troubleshooting, and repeat rather than rescue.

Data analysis

Analyze with the matching calculator or guide in Tools and Guides, keep the raw file, and record the analysis settings with the result.

Troubleshooting

Common failures and fixes are in the Troubleshooting section for this assay family. Start with the control pattern: it usually names the failing step.

Safety and waste

Standard molecular-biology PPE. Research use only. This protocol is not medical or clinical advice.

FAQ

QuestionAnswer
How long does it take?About 1 h to overnight, excluding preparation and analysis.
What is the most common failure?Skipped or failed controls, followed by samples read outside the validated range.
Can I scale it?Yes: scale reagents with the Tools calculators and keep ratios and timing unchanged.

References

Frequently asked questions

How long does it take?

About 1 h to overnight.

References

  1. Assay Guidance Manual · NCBI Bookshelf / Eli Lilly & NCATS (2024)
  2. MIQE Guidelines (Bustin et al.) · Clinical Chemistry (2009)
  3. Cold Spring Harbor Protocols · Cold Spring Harbor Laboratory Press (2024)

Do this analysis in BioStudioAI

Upload the raw file and BioStudioAI fits, quality-checks and reports it with an audit trail.

See the platform →

Related

Choosing reporter genes and their controls

Reporters (fluorescent proteins, luciferase) measure what their promoter, maturation and detection allow. Include promoter-less and constitutive contr

Screening clones: colony PCR, digest, then sequence

Screen cheap-to-expensive: colony PCR for presence/size, diagnostic digest for structure, sequencing for truth at every junction. Each stage discards

Choosing a cloning strategy: restriction, Gibson or Golden Gate

Choose restriction cloning for simple single inserts with good sites, Gibson/isothermal assembly for scar-light multi-fragment builds, and Golden Gate

Molecular cloning